ISE SMART CONNECT KNX NUSSBAUM
The ISE SMART CONNECT KNX NUSSBAUM integrates the innovative Therm-Control single-room control by NUSSBAUM into the KNX system.*
Up to five base stations can be controlled with the ISE SMART CONNECT KNX NUSSBAUM. Up to 8 room temperature controllers and 12 outlets can be connected to each of these base stations.
For more information on the Therm-Control, please see www.nussbaum.ch
Intelligent energy saving
During longer periods of absence, such as holidays or business trips, you can simply set the system into absence mode. You can also define your scheduled return time. The system will make sure that the heating is on at the right time, whilst saving considerable energy during the remaining period.

A comfortable temperature at just the right time
Cosy warmth in the bathroom in the morning, soothing coolness in the bedroom at night. The Therm-Control will take care of the rest.

While you’re away
With remote access, such as the ISE SMART CONNECT KNX REMOTE ACCESS and a KNX visualisation, you can easily adjust the temperature to suit your individual requirements even when you’re not at home.

+ POINTS
+ Saving energy during longer absences
+ Integration of panel heating into usage scenarios
+ Integration into visualisations, e.g. Gira HomeServer, Gira X1
+ Absence mode and scheduled return can be configured
+ Hydraulic balancing takes place automatically and permanently
+ Switching between heating and cooling mode
Communication + Installation
The ISE SMART CONNECT KNX NUSSBAUM is simply connected to your KNX installation and the home network on which your Therm-Control base station with WLAN module is also located.

Features
|
|
Technical data
Voltage: |
DC 24 V to 30 V |
Power consumption: |
2 W |
IP communication: |
Ethernet 10/100 BaseT |
KNX communication: |
KNX/TP, S-Mode |
KNX medium: |
TP1-256 |
Connections: |
2x RJ45 (integrated switch) Connection and branching terminals for KNX and 24 V |
Ambient temperature: |
0 °C to +45 °C |
Dimensions: |
2 TE (REG plus) |
Note:
- Power supply via external DC 24 V
- For ETS5 or higher
- * If you wish to use the ISE SMART CONNECT KNX Nussbaum, you must use Therm-Control in version 3 or higher with firmware version 2.8-4.43 or higher, supplied by R.Nussbaum AG.
Ordering info
The device is exclusively available from Nussbaum. You can find more information about the ordering from the manufacturer:
R. Nussbaum AG
Martin-Disteli-Strasse 26
CH-4601 Olten
Tel. 062 286 81 11

Downloads
-
Sources of supply
ise Individuelle Software und Elektronik GmbH
Osterstraße 15
D-26122 OldenburgPhone: +49 441 680 06 11
Fax: +49 441 680 06 15